customer concern about check engine light and car running rough, squealing noise on brakes. Proceed to scan vehicle finding 2 active codes: DTC (2) 1.190302 Diagnostic Module For Tank Leaks (NVLD), Fuel Tank Ventilation System, Micro-Leak Greater Than 0.5 mm Detected Permanent 2.118002 Mixture Control: Fuel-Air Mixture Too Rich proceed to smoke test finding leak on purge valve suggest replace part and retest. this part replacement will fix second code active too. While the car has been diagnose, found code 1.480A12 Brake Pad Wear Sensor: Rear Axle, Replace Brake Pads confirmed with less than 3mm pad life on rear end of the car. Traces of coolant leak from oil filter housing, suggest replacing. 2 rear tires with thread wear 1/32 pass & 2/32 driver suggest replace both and perform an alignment.
BRAKE PADS – Remove & Replace – Rear, Both Sides – [ DOES NOT include refinishing.]
FUEL TANK VENT VALVE – Remove & Replace
Tires – Mount & Balance
Lekida S. gave our service a 5 star review on 5/1/2026
Car towed to shop, battery good but alternator not charging, suggest replace alternator and verify other codes related to under voltage. The following are repairs that needs to be addressed as a priority: Oil filter/Cooler Housing, Transfer Case Fluid Maintenance, Two (2) Front Lower Thrust Arms and Rear Brake Pads. Customer also need to address the following at his earliest convenience: Power Steering Lines both leaking from reservoir and Serpentine Belt
ALTERNATOR ASSEMBLY – Remove & Replace
Neeraj S. gave our service a 5 star review on 2/10/2026
Front struts – both – bad Rear Wheel bearings and hubs – both – bad Rear Axle seal (differential) – both – leaking Oil drain plug washer needs to be replaced – leaking Front tires – both – need to be replaced Alignment needed.
WHEEL BEARING – Remove & Replace – Rear,Both
(COMBINATION) DIFFERENTIAL OUTPUT SEAL – Remove & Replace – Both,Rear